TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 106 of 953
3-45. HAND THROTTLE CONTROL CABLE AND BRACKET REPLACEMENT This task covers: a. Removal b. Installation 1. Remove four screws (6) and instrument cluster (7) from instrument panel (3) and pull instrument cluster (7) away to allow access to speedometer cable (4). 2. Loosen nut (5) and disconnect speedometer cable (4) from speedometer (1). 3. Remove hitch pin (19) and washer (18) and disconnect hand throttle clevis (16) from accelerator rod (17). 4. Remove locknut (8), washer (9), screw (10), washer (9), and hand throttle cable (11) from bracket (12). Discard locknut (8). 5. Remove two locknuts (13), washers (14), capscrews (20), washers (14), and bracket (12) from cowl (15) Discard locknuts (13). 6. Loosen nut (25) and hand throttle cable (11) from bracket (23). 7. Remove locknut (21), washer (28), capscrew (27), and washer (28) from bracket (23) and instrument panel (3). Discard locknut (21). 8. Remove nut (22), screw (24), and bracket (23) from instrument panel (3). 9. Remove setscrew (30) and handle (31) from hand throttle cable (11). 10. Remove nut (25), O-ring (33), and nut (26) from hand throttle cable (11). Discard O-ring (33). a. Removal INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Four locknuts (Appendix G, Item 70) O-ring (Appendix G, Item 212) Personnel Required One mechanic One assistant Manual References TM 9-2320-280-24P TM 9-2320-280-20-2 3-84 Change 3 1 2 3 4 5 6 7