TM-9-2320-280-20 HMMWV Technical Manual Unit Maintenance Volume 2 Download
Page 102 of 953
1. Connect accelerator cable (3) to injection pump throttle shaft (6). 2. Position throttle shaft lever (5) to full throttle position and install accelerator cable (3) with accelerator cable clip (1) to injection pump throttle shaft (6). 3. Connect throttle return spring (4) to engine bracket (7). 4. Install cable assembly (3) to engine bracket (7) and tighten two nuts (2). 5. Install clamp (17) to cable assembly (3) and install clamps (14) and (17) to “A” beam (16) with capscrew (15) and nut (18). 6. Install accelerator cable clevis (26) to body bracket (21) with capscrew (25), washer (20), and nut (19). 7. Position gasket (13) to cowl (28). 8. Lubricate accelerator bushing halves (12) and accelerator pedal rod (22) at accelerator rod retainer (32) with lubricating oil. 9. Position accelerator rod retainers (32) and bushing halves (12) onto accelerator pedal rod (22) ensuring retainers (32) are properly seated over bushing halves (12). 10. Install accelerator rod retainers (32), accelerator pedal rod (22), and gasket (13) to cowl (28) with three capscrews (33), washers (31), washers (31), and locknuts (30). Install clamp (29) to bottom capscrew (33) with assembled locknut (27). 11. Connect hand throttle clevis (11) to accelerator pedal rod (22) with washer (10) and hitch pin (9). 12. Connect accelerator cable clevis (26) to accelerator pedal rod (22) with washer (24) and cotter pin (23). 1. Loosen accelerator cable nuts (2) on engine bracket (7). 2. Fully depress accelerator pedal. 3. Hold throttle shaft lever (5) in full throttle position. 4. Adjust accelerator cable nuts (2) up or down so cable end (8) holds throttle shaft lever (5) in full throttle position. 5. Tighten nuts (2) securing accelerator cable (3) to engine bracket (7). 6. Release accelerator pedal and ensure throttle shaft lever (5) returns all the way to idle position. d. Adjustment c. Installation 3-42. ACCELERATOR LINKAGE MAINTENANCE (Cont'd) TM 9-2320-280-20-2 3-80 Change 3