TM-9-2320-280-10 HMMWV Operator Manual Download
Page 223 of 405
TM 9-2320-280-10 2-41. TROOP/CARGO WINTERIZATION HEATER OPERATING INSTRUCTIONS a. General. Troop/cargo winterization heater is for use during extremely cold temperatures from 0°F (-18°C) to -50°F (-46°C). CAUTION Do not operate troop/cargo heater in ambient temperatures above 0°F (-18°C), or with fan switch in “HI" position, when temperature is above -25°F (-32°C). Damage to equipment will result. NOTE Heater may be operated with engine running or engine off. b. Starting Heater. (1) Set heater fan switch (4) to "LO" position. (2) Move heater control switch (2) to "START position and hold for approximately two minutes or until heater starts and heater indicator light (1) comes on. (3) When heater starts, move heater control switch (2) to “RUN" position. The heater indicator light (1) will remain illuminated. (4) Set heater fan switch (4) to desired position ("HI" or “LO"). NOTE To defrost the interior of the troop/cargo enclosure, the diverter assembly door should be shut or in the closed position. (5) Adjust diverter assembly (3) to regulate amount of outside and inside air to be circulated through the heater assembly and into the troop/cargo area. c. If Heater Fails to Start: NOTE If the start switch is moved from the “START" to “RUN" position too quickly, the heater flame will be extinguished and the heater will need restarting. (1) Move heater control switch (2) to ”OFF" position for 10 seconds, and then back to “START" for 60 seconds. Repeat procedure if heater doesn't start. (2) Press heater indicator light (1) to test electrical circuit. (3) If heater indicator light (1) works and heater still fails to start in approximately three minutes, service is required. d. Shutting Heater Off. Move heater control switch (2) to ”OFF." NOTE The heater indicator light will remain on and the fan will continue to run until the heater has purged itself of fuel. 2-164