TM-9-2320-280-10 HMMWV Operator Manual Download
Page 213 of 405
2-154 Change 1 (6) Loosen clamp (2) securing weathercap (1) to air intake assembly (3) and remove weathercap (1). (7) Remove nut (7), washer (5), capscrew (4), washer (5), and air intake assembly (3) from windshield mounting bracket (6). (8) Disconnect fuel tank vent line (11) from intake assembly vent tube (8). (9) Loosen clamp (9) securing air intake assembly (3) to cowling (10) and remove air intake assembly (3) and clamp (9). (10) Install shield (12) in cowling (10) with three washers (13) and capscrews (14). (11) Install weathercap (1) and clamp (2) on shield (12) and tighten clamp (2). (12) Lower and secure hood (para. 3-8). (13) Clean and stow intake and exhaust assembly components. (14) If fording operation was through salt water, wash and wipe off all salt deposits as soon as possible. NOTE To prevent parking brake linkage from binding, lithium grease should be used after operating in mud. Clean mud, grit, and debris from linkage. Apply lithium grease (Appendix D, Item 10.1) and move linkage back and forth to work into joints. (15) Vehicles completing deep water fording operation must be lubricated and serviced by unit maintenance as soon as possible. TM 9-2320-280-10