TM-9-2320-280-10 HMMWV Operator Manual Download
Page 178 of 405
TM 9-2320-280-10 2-124.2 Change 1 b. Reversible Rake/Hoe Attachment. (1) Connect rake/hoe attachment (2) (with either rake or hoe in the working position) into socket (4) on end of ax (1). NOTE Thumbscrew must be seated tightly in rake/hoe attachment and socket of ax. Check thumbscrew often to be sure it does not work loose. (2) Install thumbscrew (3) on rake/hoe attachment (2) and in socket (4) of ax (1). Tighten thumbscrew (3). (3) To remove rake/hoe attachment (2), remove thumbscrew (3) from rake/hoe attachment (2) and ax (1). c. Shovel Attachment. NOTE Shovel attachment is shown. Broad pick, pick, and mattock attachments are attached basically the same. (1) Connect shovel attachment (5) into socket (4) on end of ax (1). (2) Insert safety locking pin (6) into hole in end of taper on shovel attachment (5). (3) To remove shovel attachment (5), remove safety locking pin (8) from shovel attachment (5) and ax (1). d. Tool Installation. (1) Replace attachments in the max tool kit case (7). (2) Install max tool kit case (7) and ax (1) with two strap assemblies (9) in right footwell (8) of vehicle. REVERSIBLE RAKE/HOE ATTACHMENT SHOVEL ATTACHMENT