TM-10-5411-231-13&P HMMWV Cargo Bed Cover Operator, Unit and Direct Support Download
Page 49 of 128
TM 10-5411-231-13&P CARGO BED COVER (CBC) HMMWV, TYPE I 0010 00 SERVICE UPON RECEIPT THIS WORK PACKAGE COVERS: Unpacking, Assembly and Preparation for Use, Installation INITIAL SETUP: Maintenance Level Personnel Required Unit Forklift Operator Tools and Special Tools 2 Personnel (Non MOS specific) Wrench, 9/16” Socket Philips #3 Screwdriver 1-Ton Lifting Device 7/32” Allen Wrench UNPACKING The CBC is shipped as a complete, self-contained assembly. It is bolted to a wooden pallet, compatible with 463L specifications. The CBC is attached to the pallet with three bolts, rubber gaskets, flat washers and nuts at the forward end and three screws, mounting plates, flat washers and nuts at the aft end. 1. Using socket wrench, remove three bolts, rubber gaskets and nuts holding forward end of the CBC to the pallet. 2. Using screwdriver, remove three screws, mounting plates, washers and nuts holding aft end of the CBC to the pallet. Save hardware in a plastic bag for future use in reshipment. CHECKING UNPACKED EQUIPMENT Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the damage on SF 361, Transportation Discrepancy Report. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in accordance with applicable service instructions (e.g. for Army instructions, see DA PAM 738-750) ASSEMBLY AND PREPARATION FOR USE The CBC requires an installation kit to be installed onto a HMMWV vehicle. It is installed as a complete unit. No assembly is required. Open both ventilators to allow fresh air to be circulated. If electronic equipment is to be used inside the CBC, determine if electrical power will be supplied from the road side or curb side of theCBC. Open the access plate facing the power source by rotating it counterclockwise. When opened, the access plate will be suspended by a lanyard attached inside the CBC. 0010 00-1