TM-10-5411-205-13 HMMWV S-250/G Shelter Operator, Unit and Direct Support Download
Page 91 of 127
TM 10-5411-205-13 4-7. Delamination Repair (cont). (3) Drill 3/16 inch diameter pressure release holes no closer than 1/2 inch from edge of delaminated surface. Number of holes should be determined by size of delamination area. (Release holes should be approximately 2 inches apart.) Figure 4-1. Skin Panel Delamination Repair. WARNING Gloves are to be worn when mixing and due to possible skin irritation caused by tact with the body skin surface. NOTE applying adhesive material adhesive coming into con- The Versamid material is extremely sensitive to moisture absorp- tion. Therefore, make sure Versamid 140 container has lid firmly replaced after material has been removed from shipping or storage container. Both the Epic R1003 and the Versamid 140 materials have a shelf life of one year. (4) Using the outline of the marked delaminated area, mask off the surrounding area (approximately a width of 2 feet) with kraft wrapping paper or newspaper. Using unwaxed clean containers, mix thoroughly the Epic Resin and Versamid material as follows: (a) Mixing by wieght -- Mix 15 ounces Epic R1003 to 5 ounces of Versamid 140. (b) By volume -- 2 parts of Epic R1003 to 1 part of Versamid 140. 4-4