TM-10-5411-205-13 HMMWV S-250/G Shelter Operator, Unit and Direct Support Download
Page 80 of 127
TM 10-5411-205-13 3-33. Skid Assembly. This task covers a. Inspect d. Repair b. Remove e. Assemble c. Disassemble f. Install INITIAL SETUP Tools Materials/Parts General Mechanic’s Automotive Tool Kit Sealer (Item 28, Appendix D) a. Inspect. WARNING Prior to attempting to perform maintenance on the skids, ensure that shelter is supported properly to prevent injury to personnel. (1) Inspect for secure mounting and dents. (2) Inspect for damage to skirts (1, Figure 3-36). CAUTION The shelter should be raised and supports placed on the bottom of the front and rear panels between skids. The skids should be approximately one foot above the ground. NOTE Although the skids may be damaged with dents, they can be used again if the skirts and spring are replaced. b. Remove. (Figure 3-35) (1) (2) (3) (4) Remove and retain three hex-head bolts (1) attaching each end of skid assembly (2) to underside of towing brackets, and remove plates (3). Remove and retain 24 phillips head screws (4) attaching skid (2) to side panel of shelter. Remove and retain 1x2 phillips head screws (5) attaching skid to underside of shelter floor panel, and remove skid (2) and two rubber blocks (6). Inspect condition of rivnuts (7 and 8) and replace if necessary (paragraph 3-9.b). 3-63