TM-10-5411-205-13 HMMWV S-250/G Shelter Operator, Unit and Direct Support Download
Page 68 of 127
TM 10-5411-205-13 3-25. Directional Vane Assembly and Air Intake Filter. This task covers: a. Inspect b. Replace INITIAL SETUP Tools Materials/Parts General Mechanic’s Automotive Tool Kit Sealer (Item 28, Appendix D) a. Inspect. (1) Inspect for damaged directional vane assembly. (2) Inspect for loose or missing attaching hardware. b. Replace. (Figure 3-27) (1) (2) (3) (4) Remove and retain four phillips head screws (1) and lock washers (2) and take directional vane assembly (3) off inside of inner door assembly (4). Remove air intake falter (5). Inspect condition of rivnuts (6) and replace if necessary (paragraph 3-9. b). Replacement rivnuts must have same inside diameter and thread size as rivnut removed. Dip new rivnuts in sealer prior to installation. Position air intake falter (5) in recess on inside of inner door assembly (4). Position directional vane assembly (3) on inner door assembly (4) over falter (5). Make sure vanes are aiming up toward interior of shelter, as shown in figure 3- 27. Dip four phillips head screws (1) in sealer and install with four lock washers (2). 3-51