TM-10-5411-205-13 HMMWV S-250/G Shelter Operator, Unit and Direct Support Download
Page 65 of 127
TM 10-5411-205-13 3-24. Louver Assembly, Holder Assembly and RFI/EMI Filter. This task covers a. Inspect b. Remove c. Repair d. Install INITIAL SETUP Tools General Mechanic’s Materials/Parts Automotive Tool Kit Sealer (Item 28, Appendix D) Sealer, Silicone (Item 26, Appendix D) NOTE RFI/EMI falters are on inner door assembly are on shielded shelters only. a. Inspect. (Figure 3-26) (1) Inspect holder assembly (4) for secure mounting or damaged parts. (2) Inspect louver assembly (12) for external damage. (3) Inspect frame (18) and frame assembly (11) for secure mounting. b . Remove. (Figure 3-26) (1) (2) (3) (4) (5) (6) Prop louver cover assembly open. Remove and retain four phillips head screws (1), nuts (2), and lock washers (3), and remove holder assembly (4) from frame assembly (11). Punch out groove pin (5) to remove holder (6) from bracket assemblies (7). Remove and retain 31 phillips head screws (8), nuts (9), and lock washers (10) attaching frame assembly (11) to inner door panel. While supporting louver assembly (12) on bottom with one hand, remove gasket (13) and frame assembly (11) from inner door assembly (14). Slide louver assembly (12) and gasket (13) out of frame assembly (11). Remove and retain seven phillips head screws (15), nuts (16), and lock washers (17) attaching frame (18) to inner door assembly (14). Remove frame (18), shield (19), and RFI/EMI filter (20). c. Repair. Repair consists of replacing missing, damaged or defective parts. 3-48