TM-10-5411-205-13 HMMWV S-250/G Shelter Operator, Unit and Direct Support Download
Page 58 of 127
TM 10-5411-205-13 3-20. Keeper Assembly. This task covers: a. Inspect b. Replace INITIAL SETUP Tools General Mechanic’s Materials/Parts Automotive Tool Kit None a. Inspect. (Figure 3-22) (1) Inspect for wear and other physical damage. (2) Inspect for secure mounting. (3) Inspect latch lock assembly (8) for wear or damage. b. Replace. (Figure 3-22) (1) (2) (3) (4) (5) (6) NOTE The middle keeper on each door is tapped for attachment of a latch lock assembly. Maintenance procedures are the same for all keep- ers and on both the outer door and inner door assemblies. Remove and retain hex-head screw (1), lock washer (2), and flat washer (3) from top (upper) hole of keeper assembly (4). Remove and retain hex-head screw (5), lock washer (2), and flat washer (3) from bottom (lower) hole of keeper (4) attaching each of the keepers (4) and shim (6) and laminated shim (7) to wall and remove. If only latch lock assembly (8) has to be removed, remove and retain hex-head screw (5), lock washer (2), and flat washer (3) attaching tab of latch lock assem- bly (8) to center keeper at the bottom (lower) hole, and remove latch lock. Position laminated shim (7), shim (6), and each keeper (4) in place and secure to shelter wall at top hole using hex-head screw (1), lock washer (2), and flat washer (3). Secure keeper (4) to wall at bottom hole using hex-head screw (5), lock washer (2), and flat washer (3). If only latch lock assembly (8) has to be installed, position latch lock tab in place over bottom mounting hole of center keeper (4), and secure using hex- head screw (5), lock washer (2), and flat washer (3). 3-41