TM-10-5411-205-13 HMMWV S-250/G Shelter Operator, Unit and Direct Support Download
Page 55 of 127
TM 10-5411-205-13 3-19. Door Handle Assembly and Latching Mechanism (cont). (4) (5) (6) (7) (8) (9) (10) Punch out grooved pin (9) from underside of latch arm assembly (10) and remove grooved pin (9) to release the latch arm assembly (10). Pull outside handle assembly (8) out of door. Remove o-ring (15) from place on outside handle shaft (8). Turn the bearing sleeve nut (16) counterclockwise to release the handle shaft sleeve (17) and remove nut (16) and shaft sleeve (17). Punch out spring pin (11) and release the roller extension (12) and roller latch (13) from latch arm (14). Punch out spring pin (1) and release flat washer (2), pin (18), and latch rod assembly (5). Remove nut (19) to release washer (20), spacer (21), latch arm assembly (10), spacers (22, 24, and 25), latch arm detent (23), (at the bottom latch installation only), and bolt (26). Remove rivet (27) attaching padlock and chain (28) to panel and remove padlock. (Refer to paragraph 3-9.a for rivet removal instructions.) d. Assemble. (1) (2) (3) (4) NOTE Assembly procedures are similar for top and bottom sections of door latch assembly. Place mounting end of padlock and chain (28) over mounting hole and secure with rivet (27). (Refer to paragraph 3-9.a for rivet installation instructions.) Place roller extension (12) and roller latch (13) on to latch arm (14) and secure with spring pin (11). NOTE When installing the latch arm detent (23) at the bottom section of the assembly, have the latch mechanism fully open so that the raised surface is engaged in the hole of the latch arm assembly (10). Then secure all components by tightening nut (19). Apply conductive compound under head of each bolt (26) and place bolt through mounting hole on door. Insert spacers (24 and 25), latch arm detent (23), spacer (22), (at top of installa- tion), latch arm assembly (10), spacer (21), and washer (20) on bolt (26), and secure with nut (19). 3-38