TM-10-5411-205-13 HMMWV S-250/G Shelter Operator, Unit and Direct Support Download
Page 50 of 127
TM 10-5411-205-13 3-18. Door Gaskets. This task covers: a. Inspect b. Test c. Adjust d. Replace INITIAL SETUP Tools Materials/Parts General Mechanic’s Automotive Tool Kit Silicone Sealer (Item 26, Appendix D) Gasket, Silicone (Item 27, Appendix D) EMI/RFI Gasket (Item 31, Appendix D) Conductive Compound (Item 33, Appendix D) NOTE RFI/EMI gaskets are only on outer and inner doors of shielded shelters. a. Inspect. (Figure 3-20) (1) Inspect the (2) Inspect the (3) Inspect the door assembly (2) for external damage. silicone weather gasket (15) for tightness. RFI/EMI gasket for wear and secure mounting. b. Test. (Figure 3-19) Test of the door assembly consists of testing for proper seal pressure on the silicone weather gasket. The procedure listed below shall be per- formed at the center top and bottom of the door, and three places along each side of the door, as shown in Figure 3-19. (1) Place a single piece of paper (0.005 inches wide) between the silicone weather gasket (2) Close and lock the door. NOTE maximum thickness by and its bearing surface. 2-1/2 inches The absence of any resistance to the withdrawal of the paper indi- cates that the gasket is not touching its bearing surface, thus in- dicating insufficient pressure. 3-33