TM-10-5411-205-13 HMMWV S-250/G Shelter Operator, Unit and Direct Support Download
Page 112 of 127
TM 10-5411-205-13 COMPONENTS OF C-1. SCOPE. APPENDIX C END ITEM AND BASIC ISSUE ITEMS LISTS Section I. INTRODUCTION This appendix lists components of end S-250/G Shielded Shelters to help you operation. C-2. GENERAL. item and basic issue items for the S-250/G Unshielded inventory items required for safe and efficient The Components of End Item and Basic Issue Items Lists are divided into the following sections: a. Section II. Components of End Item. This listing is for informational purposes only, and is not authority to requisition replacements. These items are part of the end item, but are removed and separately packaged for transportation or shipment. As part of the end item, these items must be with the end item whenever it is issued or transferred between property accounts. Illustrations are furnished to assist you in identifying the items. b. Section III. Basic Issue Items. These are the minimum essential items required to place the S-250/G Unshielded S-250/G Shielded Shelters in operation, to operate them, and to perform emergency repairs. Although shipped separately packaged, BII must be with the shelters during operation and whenever they are transferred between property accounts. The illustrations will assist you with hard-to-identify items. This manual is your authority to request/requisition replacement BII, based on TOE/MTOE C-3. EXPLANATION OF COLUMNS The following provides an explanation of columns found in a. Column (1) - Illustration Number (Illus Number). of the illustration in which the item is shown. authorization; of the end item. the tabular listings: This column indicates the number b. Column (2) - National Stock Number. Indicates the National stock number assigned to the item and will be used for requisitioning purposes. c. Column (3) - Description. Indicates the Federal item name and, if required, a minimum description to identify and locate the item. The last line for each item indicates the FSCM (in parentheses) followed by the part number. d. Column (4) - Unit of Measure (U/M). Indicates the measure used in performing the actual operational/maintenance function. This measure is expressed by a two-character alphabetical abbreviation (e.g., ea, in, pr). e . Column (5) - Quantity required (Qty rqr). Indicates the quantity of the item authorized to be used with/on the equipment. C-1