TB-9-2320-335-13&P HMMWV Operator and Field Maintenance, Parts, Tools M1151A1 M1152A1 M1165A1 Download
Page 94 of 680
TM 9-2320-335-13&P 3-12 3-25. FUEL TANK AND SHIELD MAINTENANCE (Cont’d) NOTE • Use sealing compound on all vent line and fuel line connector threads before installation. • Use fittings from old tank if installing new tank. 1. Install heat shield (21) on fuel tank (18) with three lockwashers (23), washers (24), and capscrews (22). 2. Install vent line (19) on tee fitting (20). 3. Install filler spout hose (17) on tank (18) and tighten clamp (16). 4. Apply sealing compound to threads of fuel supply tube (12). Install and align fuel supply tube (12) on access cover (11). 5. Apply sealing compound to threads of fuel return tube (33). Install and align fuel return tube (33) on access cover (11). NOTE Perform step 6 if vehicle is equipped with vehicular heater and auxiliary fuel line. 6. Apply sealing compound to threads of fuel supply tubes (13). Install and align two fuel supply tubes (13) on access cover (11). 7. Install grommet (3) and vent valve (4) on access cover (11). 8. Install fuel strainer (14) on fuel supply tube (12). 9. Apply adhesive to threads of nine locknuts (9). Install retainer (32), gasket (15), and access cover (11) on fuel tank (18) with nine washers (10) and locknuts (9). Tighten locknuts (9) to 72 lb-in. (8 N•m). 10. Connect jumper harness leads 28B (1) and 58J (2) to fuel level sender (34). 11. Apply adhesive to threads of two locknuts (7). Install jumper harness (5) on access cover (11) with two clamps (6), washers (8), and locknuts (7). Tighten locknuts (7) to 72 lb-in. (8 N•m). 12. Connect fuel supply line (31) to fuel supply tube (12), and fuel return line (30) to fuel return tube (33). NOTE Perform step 13 if vehicle is equipped with an vehicular heater and auxiliary fuel line. 13. Connect auxiliary fuel supply and return lines (25) to fuel supply tubes (13). 14. Connect crossover hose (27.2) to auxiliary fuel supply and return lines (25) and secure with two clamps (27.1) 15. Install shield (26), return line (30), supply line (31), clamp (29), and auxiliary fuel supply and return lines (25) and clamp (28), if installed, on fuel tank (18) with capscrew (27). e. Assembly