TB-9-2320-335-13&P HMMWV Operator and Field Maintenance, Parts, Tools M1151A1 M1152A1 M1165A1 Download
Page 88 of 680
3-25. FUEL TANK AND SHIELD MAINTENANCE This task covers: a. Draining d. Cleaning and Inspection b. Removal e. Assembly c. Disassembly f. Installation WARNING Diesel fuel is highly flammable. Do not perform this procedure near fire, flames, or sparks. Severe injury or death may result. NOTE Have drainage container ready to catch fuel. 1. Remove fuel tank filler cap (1). 2. Remove drainplug (3) from fuel tank (2) and allow fuel to completely drain into container. CAUTION Do not overtighten drainplug. Drainplug must not turn in hole. Sharp edge of hole may cut rubber. 3. Install drainplug (3) flush with bottom of fuel tank (2). NOTE Perform steps 1 through 1.2 if equipped with new vent line assembly. 1. Remove tiedown strap (13.1) from vent lines (14.1) and (4). Discard tiedown strap (13.1). 1.1. Remove vent line (14.1) from elbow (4.1). 1.2. Remove vent line (4) from elbow (4.2). 1.3. Remove vent line (4) from filler spout (5). 2. Remove locknut (15), washer (12), capscrew (11), washer (12), and clamp (13) from vent line (4) and body (14). Discard locknut (15). b. Removal a. Draining INITIAL SETUP: TB 9-2320-335-13&P 3-6 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: (Appendix B, Item 2) Materials/Parts Gasket (Appendix A, Item 37) Fourteen locknuts (Appendix A, Item 77) Three lockwashers (Appendix A, Item 144) Drycleaning solvent (Appendix C, Item 26) Adhesive (Appendix C, Item 2) Sealing compound (Appendix C, Item 62) Tiedown strap (Appendix A, Item 322) Personnel Required One mechanic One assistant Manual References TM 9-2320-387-10 TM 9-2320-387-24P Equipment Condition • Battery ground cables disconnected (TM 9-2320-387-24-1). • Rear propeller shaft removed (TM 9-2320-387-24-1). • Right rear upper underbody armor (integrated) removed (TM 9-2320-387-24-2). General Safety Instructions •Do not perform this procedure near fire, flames, or sparks. • Drycleaning solvent is flammable and will not be used near an open flame. Maintenance Level Unit