TB-9-2320-335-13&P HMMWV Operator and Field Maintenance, Parts, Tools M1151A1 M1152A1 M1165A1 Download
Page 404 of 680
24-20 TB 9-2320-335-13&P 24-16.1. FRONT SUSPENSION FRONT CROSSMEMBER MAINTENANCE (SERIAL NUMBERS 300000 AND ABOVE) This task covers: a. Removal c. Installation b. Inspection 1. Remove four locknuts (4), washers (5), capscrews (13), washers (12), and two splash shield brackets (3) from frame rails (23). Discard locknuts (4). 2. Remove locknut (22), washer (21), screw (17), clamp (18), and harness (16) from front crossmember (20). Discard locknut (22). 3. Remove four locknuts (2), washers (1), capscrews (9), and washers (11) from front crossmember (20) and two frame rails (23). Discard locknuts (2). 4. Remove six locknuts (6), washers (7), capscrews (15), washers (14), and brake line brackets (8) from front crossmember (20) and left and right front crossmember mounting brackets (10). Discard locknuts (6). 5. Slide crossmember (20) and mounting brackets (10) down and out from under vehicle. Inspect edge protector (19). Replace if damaged. 1. Install left and right crossmember mounting brackets (10) on front crossmember (20). 2. Install front crossmember (20) and two mounting brackets (10) on frame rails (23) with four washers (11), capscrews (9), washers (1), and locknuts (2). 3. Install brake line brackets (8) and left and right crossmember mounting brackets (10) on front crossmember with six washers (7), locknuts (6), washers (14) and capscrews (15). 4. Install two splash shield brackets (3) on frame rails (23) with four washers (12), capscrews (13), washers (5), and locknuts (4). 5. Install harness (16) on front crossmember (20) with clamp (18) and screw (17), washer (21), and locknut (22). 6. Tighten four locknuts (2). 7. Tighten four locknuts (4) and six locknuts (6). b. Installation b. Inspection a. Removal INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Fifteen locknuts (Appendix A, Item 114.4) Manual References TM 9-2320-387-24-1 Equipment Condition • Radiator removed (para. 3-62.1). • Front lower control arms removed (TM 9-2320-387-24-1). • Horn removed (para. 4-26.1). • Front differential removed (para. 21-4.1) • Differential support brackets and side mounting brackets removed (para. 24-15.1). • Front brake lines removed (para. 7-7.1).