TB-9-2320-335-13&P HMMWV Operator and Field Maintenance, Parts, Tools M1151A1 M1152A1 M1165A1 Download
Page 368 of 680
TB 9-2320-335-13&P 21-10 21-4.1. FRONT DIFFERENTIAL REPLACEMENT (SERIAL NUMBERS 300000 AND ABOVE) (Cont’d) CAUTION Apply a liberal amount of thread sealing compound to the tapped holes of differential. To allow adequate coating of threads, install capscrews shortly after applying thread sealing compound. Failure to do this could allow capscrews to loosen and cause damage to differential. 1. Apply sealing compound to tapped holes (21) in differential (19). Install two brake caliper adapters (22) on differential (19) with eight capscrews (23). Tighten capscrews (23) to 125-150 lb-ft (170-203 N•m). 2. Raise differential (19) into place and install on front crossmember (16) with two washers (17), capscrews (18), washers (14), and locknuts (15). 3. Install mounting bracket (9) on rear crossmember (8) with two washers (7), capscrews (6), washers (10), and locknuts (11). Tighten locknuts (11) to 90 lb-ft (122 N•m). 4. Apply sealing compound to capscrews (2). Secure differential (19) to mounting bracket (9) with two washers (3) and capscrews (2). Tighten capscrews (2) to 125-150 lb-ft (170-203 N•m). 5. Install propeller shaft (1) on pinion flange (5) with two straps (12) and four capscrews (13). Tighten capscrews (13) to 13-18 lb-ft (18-24 N•m). 6. Install output flange (24) on differential (19) with O-ring (25) and locknut (26). Tighten locknuts (26) to 165-195 lb-ft (224-264 N•m). b. Installation