TB-9-2320-335-13&P HMMWV Operator and Field Maintenance, Parts, Tools M1151A1 M1152A1 M1165A1 Download
Page 308 of 680
15-5. RIGHT CYLINDER HEAD REPAIR This task covers: a. Removal c. Installation b. Repair INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Materials/Parts Gasket (Appendix a, Item 53) Pipe sealing compound (Appendix C, Item 62) Cylinder head lifting device (Appendix D, Fig. D-111) (Optional) Personnel Required One mechanic One assistant Manual References TM 9-2320-387-24-1 TM 9-2320-387-24-2 TM 9-2350-387-24P TM 9-2815-237-34 Equipment Condition • Right exhaust manifold removed (TM 9-2320-387-24-1). • Water crossover removed (para. 3-79.1). • Right intake manifold removed (TM 9-2320-387-24-2). • Rocker arm shafts and pushrods removed (TM 9-2320-387-24-2). • Fuel injection return hoses removed (TM 9-2320-387-24-1). • Fuel injection nozzles removed (TM 9-2320-387-24-2). • Glow plugs removed (TM 9-2320-387-24-1). General Safety Instructions Cylinder head must be supported during removal and installation. Maintenance Level Direct support TB 9-2320-335-13&P 15-12 WARNING Cylinder head must be supported during removal and installation. Failure to support cylinder head may cause injury to personnel or damage to equipment. CAUTION Cover or plug all hoses, connections, and openings immediately after disconnection to prevent contamination. Remove all covers or plugs prior to connection. 1. Remove cold-advance switch (2) from cylinder head (1). 2. Remove seventeen capscrews (3) from cylinder head (1) and cylinder block (5). Discard capscrews (3). NOTE Use of cylinder head lifting device is optional. 2.1. Install cylinder head lifting device (1.3) on center of cylinder head (1) with two washers (1.2) and capscrews (1.1). 3. Remove cylinder head (1) and gasket (6) from cylinder block (5). Discard gasket (6). 3.1. Remove two capscrews (1.1), washers (1.2), and cylinder head lifting device (1.3) from cylinder head (1), if installed. 4. For cylinder head (1) and valve repair procedures, notify general support (TM 9-2815-237-34). Refer to TM 9-2320-387-24-1, for extraction of broken bolts. CAUTION Head gasket must be used without a sealer. Sealant may cause leaks or damage to engine. 1. Install head gasket (6) over dowel pins (4) on cylinder block (5). c. Installation b. Repair a. Removal