TB-9-2320-335-13&P HMMWV Operator and Field Maintenance, Parts, Tools M1151A1 M1152A1 M1165A1 Download
Page 298 of 680
15-2 Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Maintenance and repair shop equipment: automotive (Appendix B, Item 2) Special Tools Crowfoot, 5/8-in. (Appendix B, Item 138) Torque adapter, 9/16-in. (Appendix B, Item 133) Torque adapter, 3/4-in. (Appendix B, Item 134) Adapter, 3/8-1/2-in. (Appendix B, Item 135) Engine lifting sling (Appendix B, Item 24) Materials/Parts Three lockwashers (Appendix A, Item 144) Eight locknuts (Appendix A, Item 106) Two locknuts (Appendix A, Item 85) Personnel Required One mechanic One assistant Manual References TM 9-2320-387-24-1 TM 9-2320-387-24P Equipment Condition • Fuel pump removed (right engine mount only) (TM 9-2320-387-24-1). • Engine right splash shield removed (para. 10-24.1). • Engine access cover removed (TM 9-2320-387-24-1). • Front propeller shaft removed (left engine mount only) (para. 6-2). • Glow plug controller removed (TM 9-2320-387-24-1). • Air horn support and engine lift bracket removed (TM 9-2320-387-24-1). General Safety Instructions Direct all personnel to stand clear during hoisting operation. Maintenance Level Direct support 15-3. ENGINE MOUNT AND INSULATOR MAINTENANCE This task covers: a. Removal c. Assembly b. Disassembly d. Installation INITIAL SETUP: NOTE • Left and right engine mounts are removed basically the same. • Left and right engine mounts are not interchangeable with each other. 1. Remove two locknuts (6) and washers (7) from insulator (8) on engine mount bracket (5). Discard locknuts (6). 2. Loosen nut (9) securing starter (10) to starter support bracket (11). 3. Remove three capscrews (4) and lockwashers (3) from right engine mount (1) and cylinder block (2). Discard lockwashers (3). 4. Remove four locknuts (16), washers (15), and capscrews (13) from two radiator supports (12) and airlift brackets (14). Discard locknuts (16). a. Removal TB 9-2320-335-13&P