TB-9-2320-335-13&P HMMWV Operator and Field Maintenance, Parts, Tools M1151A1 M1152A1 M1165A1 Download
Page 240 of 680
8-20 TB 9-2320-335-13&P 7. Apply sealing compound to three capscrews (12). 8. Install steering gear (14) on frame (13) with three washers (10), lockwashers (11), bracket (9), and capscrews (12). Tighten capscrews (12) to 160–195 lb-ft (217–264 N•m). 9. Install idler arm (21) on frame (20) with two washers (22), capscrews (23), washers (18), and locknuts (19). Tighten capscrews (23) to 85 lb-ft (115 N•m). 10. Install two tie rods (26) on center link (17) with two slotted nuts (25). Tighten slotted nuts (25) to 70 lb-ft (95 N•m). 11. Install two cotter pins (24) on slotted nuts (25). 12. Align hole in yoke (16) with notch on steering gear splines (15) and slide lower steering shaft (3) on steering gear splines (15). 13. Install lower steering shaft (3) on steering gear (14) with washer (4), capscrew (6), washer (2), and lower steering shaft locknut (1). Tighten locknut (1) to 40–50 lb-ft (54–68 N•m). 14. Install two power steering lines adapters (7) on steering gear (14). 15. Install two power steering lines (5) and O-rings (8) on two adapters (8). 4 6 10 11 12 7 8 14 8 7 1 2 3 5 13 ~ 15 16 9 8-20.1. STEERING GEAR, CENTER LINK, AND PITMAN ARM REPLACEMENT (SERIAL NUMBERS 246890 AND ABOVE) (Cont’d)