TB-9-2320-335-13&P HMMWV Operator and Field Maintenance, Parts, Tools M1151A1 M1152A1 M1165A1 Download
Page 175 of 680
TB 9-2320-335-13&P 6-11 6-7. HALFSHAFT MAINTENANCE (Cont’d) NOTE • Ensure all six capscrew holes in the rotor align with holes in output flange. • New capscrews come with preapplied thread-locking compound, however, still apply sealing compound to threads of new capscrews. If old capscrews are to be used, mating threads must be cleaned and sealing compound applied to threads of capscrews. • Two-piece lockwashers must be installed in sets of two with serrated sawtooth threads facing each other. 4. Apply sealing compound to six capscrews (12). Install halfshaft (18) on rotor (10) and output flange (19) with six two-piece lockwashers (11) and capscrews (12). Tighten capscrews (12) to 58 lb-ft (79 N•m). NOTE Perform steps 5 through 7 for rear halfshafts only. 5. Install parking brake cable (27) on caliper cable bracket (20) with clip (21). CAUTION • Ensure lever is in contact with caliper cable bracket stop. Damage to equipment and poor performance may result if not aligned properly. • Ensure that clevis and clevis pin are aligned in lever. Do not move lever to accommodate misadjusted clevis. Damage to equipment and poor performance may result. 6. Install parking brake clevis (25) on lever (22) with clevis pin (26), washer (24), and cotter pin (23). Check position of lever (22) and ensure it is in contact with caliper cable bracket stop (28). 7. If lever (22) is not in contact with caliper cable bracket stop (28), adjust rear dual service parking brake (para. 7-19). FOLLOW-ON TASKS: • Install brake protection guards (para. 7-11.1). • Install wheel (TM 9-2320-387-24-1). 17 16 15 14 13 19 10 11 12 11 12 24 20 25 26 27 28 22 22 23 21 20 18