TB-9-2320-335-13&P HMMWV Operator and Field Maintenance, Parts, Tools M1151A1 M1152A1 M1165A1 Download
Page 152 of 680
TB 9-2320-335-13&P 5-2 5-3.1. TRANSMISSION OIL COOLER LINES REPLACEMENT (SERIAL NUMBERS 300000 AND ABOVE) WARNING Allow transmission to cool before performing this procedure. Severe injury to personnel may occur. CAUTION Cover or plug all open lines and connections immediately after disconnection to prevent contamination. Remove all plugs prior to connection. Failure to comply may result in equipment damage. NOTE Geared fan vent tube may need to be removed before removing front transmission oil cooler lines. 1. Remove hose clamp (22) from hose (21) and line (15). 2. Remove capscrew (25), lockwasher (24), clamps (23) and (26), and lines (14) and (15) from bracket (18). Discard lockwasher (24). 3. Remove capscrew (30), washer (29), clamps (28) and (27), and lines (14) and (15) from bracket (17). 4. Remove capscrew (34), washer (33), clamps (32) and (31), and lines (14) and (15) from bracket (16). 5. Remove locknut (13), washers (12) and (41), capscrew (10), and clamps (11) and (40) from lines (14) and (15). Discard locknut (13). 6. Remove hose clamp (42) and hose (43) from line (15). 7. Remove hose clamps (36) and (44) and tube (37) from hoses (35) and (43). 8. Remove hose clamp (39) and hose (35) from adapter (38). 9. Remove adapter (38) from oil cooler connector (1). 10. Remove hose clamp (6) and hose (5) from line (14). 11. Remove hose clamps (4) and (45) and tube (3) from hoses (5) and (9). 12. Remove hose clamp (8) and hose (9) from adapter (7). 13. Remove adapter (7) from oil cooler connector (2). 14. Remove hose clamp (19) from hose (20) and line (14). 1. Install hose (21) on line (15) with hose clamp (22). 2. Install hose (20) on line (14) with hose clamp (19). 3. Install clamps (23) and (26) and lines (14) and (15) on bracket (18) with capscrew (25) and lockwasher (24). b. Front Lines Installation a. Front Lines Removal This task covers: a. Front Lines Removal c. Rear Lines Removal b. Front Lines Installation d. Rear Lines Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/Parts Lockwasher (Appendix A, Item 144) Locknut (Appendix A, Item 106) Manual References TM 9-2320-387-10 TB 9-2320-335-13&P, Appendix E Equipment Condition Engine right splash shield removed (front lines) (para. 10-24.1). General Safety Instructions Allow transmission to cool before performing this task. Maintenance Level Unit