TB-9-2320-280-35-15 HMMWV Technical Bulletin Installation for Retransmission EPLRS Network Manager Download
Page 116 of 168
5-92 TB 9-2320-280-35-15 SECTION XXXVIII. SINCGARS ON RIGHT-SIDE PEDESTAL MOUNT CABLES INSTALLATION 38-1. Locate, mark, and drill one 0.225-in. hole (8) in inboard corner on rear inside lip of left rear seat back support (6). 38-2. Locate, mark, and drill two 0.147-in. holes (5) in front face of right rear wheelwell (13). 38-3. Route antenna cable (4) along rear perimeter of right rear seat back support (6), up front face of left rear wheelwell (13), and up antenna base (1). NOTE Clamps are large to accommodate black charger cable from power entry box in step 38-4. 38-4. Secure SINCGARS antenna cable (4) to seat back support (6) with screw (7), lockwasher (9), nut (10), two self-tapping screws (12), two existing screws (2), and five loop clamps (3). 38-5. Secure antenna cable (4) to antenna base (1) with clamps (16), existing screws (17), washers (15), lockwashers (14), and nuts (18). 38-6. Connect antenna cable (4) to antenna (19). Route antenna cable (4) through multi-net rack (11) to vicinity of SINCGARS mount. 38-7. Tighten all screws and nuts on all clamps. 38-8. Secure right-side tunnel insulation. (Refer to TM 9-2320-280-20.)