TB-9-2320-280-35-14 HMMWV Technical Bulletin Installation for SINCGARS FBCB2 PLGR EPLRS 150W Radio Download
Page 74 of 148
5-52 TB 9-2320-280-35-14 5. CAPSCREW – B1821BH025C125N – QTY. 4 6. LOCKWASHER – MS45904-72 – QTY. 16 7. CAPSCREW – B1821BH031C100N – QTY. 8 8. RESILIENT MOUNT – MT-6146/VSQ-1 – QTY. 1 9. NUT – 9417954 – QTY. 8 11. SPACER – A3046313 – QTY. 4 13. NUT – 9419143 – QTY. 4 14. LOCKWASHER – MS45904-68 – QTY. 4 15. WASHER – 2436161 – QTY. 8 Figure 5-70. ~ 12 9 6 13 14 15 16 15 5 4 6 7 8 1 6 9 6 7 10 4.25 NOTE Procedure requires removal and reinstallation of left rear side rail, which may require assistance. (Refer to TM 9-2320-280-20.) Perform steps 21-3, 21-5, 21-6, 21-8, and 21-10 only for vehicles equipped with rear side rails. 21-3. Remove left rear side rail (4). 21-4. Using mounting plate (1) as template, locate, mark, and drill four 0.343-in. diameter holes (10) and four 0.281-in. diameter holes (16) in left rear wheelhouse (12). 21-5. Reinstall left rear side rail (4). Do not tighten screws. 21-6. Using mounting plate (1) and left rear wheelhouse (12) as template, drill four holes in left rear side rail (4) from underside of left rear wheelhouse (12). 21-7. Install resilient mount (8) on mounting plate (1) with four capscrews (7), eight lockwashers (6), and four nuts (9). 21-8. Remove paint from vicinity of eight mounting holes (16) and (10) on left rear wheelhouse (12). Apply anti-seize compound as required. Position mounting plate (1) between left side rail (4) and left rear wheelhouse (12) and align all holes. 21-9. Install mounting plate (1) on left rear wheelhouse (12) with four capscrews (5), lockwashers (14), eight washers (15), four nuts (13), capscrews (7), eight lockwashers (6), four spacers (11), and nuts (9). 21-10. Tighten all left rear side rail (4) screws. 11