TB-9-2320-280-35-13 HMMWV Technical Bulletin Installation for SINCGARS FBCB2 PLGR EPLRS 20W Radio Download
Page 93 of 148
5-65 TB 9-2320-280-35-13 29. EPLRS ANTENNA CABLE – SM-C-911480 – QTY. 1 33. CAPSCREW – B1821BH025C075N – QTY. 2 37. GROMMET – MS21266-4N – QTY. A/R 41. LOOP CLAMP – MS21333-104 – QTY. 2 42. LOCKWASHER – MS35338-44 – QTY. 2 43. NUT – 9419143 – QTY. 2 Figure 5-85. 34 35 36 37 38 39 40 33 29 42 43 41 42 41 33 43 4.50 39 29 41 44 NOTE • If soft top has been installed, roll back to allow clearance for routing of antenna cable in steps 21-16 through 21-19. • Lay out all cables in their approximate positions before clamps are installed. This will minimize cable length, and ensure all slack is taken out of all cables from front of vehicle to rear. • Excess slack in all cables will be stored under EPLRS mount assembly. • It may be necessary to drill one 0.281-in. diameter hole in right side of antenna base bracket for antenna cable clamp. (Refer to figure 5-83.) 21-15. Locate, mark, and drill one 0.281-in. diameter hole (40) in left overhead rail (39). 21-16. Route antenna cable (29) through hole (38) in overcab mount (34) and antenna base bracket (36) and connect to antenna (35). 21-17. Install grommet (37) in antenna base bracket (36) and overcab mount (34). 21-18. Secure antenna cable (29) to left overhead rail (39) and antenna base bracket (36) with two loop clamps (41), capscrews (33), lockwashers (42), and nuts (43). 21-19. Route antenna cable (29) down along left overhead rail (39) and secure with loop clamp (41) and existing screw (44). 21-20. Route antenna cable (29) to B-beam. 3.25 1.75