TB-9-2320-280-35-12 HMMWV Technical Bulletin Installation for EPLRS Network Manager Download
Page 37 of 162
TB 9-2320-280-35-12 5-12.1 19 20 18 21 22 23 28 27 24 25 26 1. LOCKWASHER – MS35338-44 – QTY. 4 3. CAPSCREW B1821BH025C100N – QTY. 1 18. LANYARD – 8925T5-7X19 – QTY. 1 19. SPACER – 10705AL315C – QTY. 4 20. WINGNUT – MS51553-420 – QTY. 4 21. DISPLAY LOCK ASSEMBLY – 872843-1 – QTY. 1 22. DISPLAY ISOLATION KIT – 872870-1 – QTY. 1 24. DISPLAY – 881293-1 – QTY. 1 25. SCREW – MS35190-291 – QTY. 2 26. RAMBALL MOUNT – RAM-D-111U – QTY. 1 27. DISPLAY GROUND STRAP • BRAIDED WIRE – AA59569F30T0375 – QTY. A/R • TERMINAL LUG – MS20659-141 – QTY. 2 28. NUT – MS35649-2252 – QTY. 3 29. WASHER – 2436161 – QTY. 1 30. BOLT – MS35751-18 – QTY. 4 6-8. Install ramball mount (26) on integrated rack (7) with two screws (25), screw (3), lockwasher (1), lanyard (18), washer (29), three lockwashers (1), and nuts (28). 6-9. Install display isolation kit (22) on display lock assembly (21) with four bolts (30), spacers (19), lanyard (18), and four wingnuts (20). 6-10. Install display unit (24) on display isolation kit (22) with four screws (23). 6-11. Install display lock assembly (21) on ramball mount (26). 6-12. Fabricate display ground strap (27) from 8-in. length of braided wire and two terminal lugs. NOTE Remove paint from vicinity of integrated rack mounting hole before performing step 6-13. Apply anti-seize compound as required. Ground strap will be installed on integrated rack only when integrated rack is fully secured in vehicle. 6-13. Install display ground strap (27) on display ground stud (33) with existing lockwasher (32) and wingnut (31). Figure 5-18. 29 3 1 30 33 32 31 27 1 Change 1 7