MWO-9-2330-390-35-1 HMMWV M1022A1 Dolly Set Positioning Tube Reinforcement Download
Page 5 of 48
MWO 9-2330-390-35-1 5 9. SPECIAL TOOLS; TOOL KITS; JIGS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND FIXTURES REQUIRED. a. Hand tools and tool kits necessary to apply MWO are listed: NOMENCLATURE NSN CAGEC SUPPLY CATALOG Tool Kit, General Mechanic’s 5180-00-177-7033 50980 SC 5180-90-N26 Kit, Redundant Power 1730-01-4062585 21439 8D00220-1 Wrench, Twist Lock 21439 8D00136 (Provided w/ Dolly) Drill Set, Twist 5133-00-293-0983 55719 SC 4910-95-CL-A74 Drill, Electric, Portable 5130-00-293-1849 81348 SC 4910-95-CL-A74 Welder, Short Arc Mig 3431-01-071-9104 30367 P/N SWM-14 b. Tools necessary to apply MWO are contained in the following shop set: NOMENCLATURE NSN CAGEC SUPPLY CATALOG Shop Equipment, Automotive Maintenance And Repair 4910-00-754-0654 19204 SC 4910-95-A74 10. MODIFICATION PROCEDURE. WARNING Use extreme caution when handling heavy parts. Lifting device is required when parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 Kg) for a two person lift, and over 150 lbs (68 kg) for a three or more person lift. Keep clear of heavy parts supported only by lifting device. Failure to follow this warning may cause serious injury or death to personnel NOTE • Hydraulic lines should be tagged before removal. • Positioning cylinder ports should be plugged with masking tape or other suitable means as lines are disconnected or fittings are removed. • A suitable container should be used to catch any draining hydraulic fluid. Ensure that all spills are properly cleaned. a. DOLLY PREPARATION NOTE • Preparation procedures are the same for front and rear dollies. 1. Uncouple Dolly set from Tow vehicle 2. From the transport or travel mode (Figure 2) perform operations needed to detach front and rear dollies (Refer to Appendix A).