MWO-9-2330-390-35-1 HMMWV M1022A1 Dolly Set Positioning Tube Reinforcement Download
Page 34 of 48
MWO 9-2330-390-35-1 C-1 APPENDIX C: TOP AND BOTTOM BEAM AND HYDRAULIC LIFT CYLINDER REMOVAL / INSTALLATION a. REMOVAL WARNING • DO NOT disconnect hydraulic lines and fittings while engine is running or before hydraulic system pressure has been released. When engine is running, hydraulic system is under pressure. Dolly set must be fully lowered on to the blocks and the engine must be shut down before lines and fittings are disconnected. A line or fitting disconnected under pressure will explode with great force and cause serious injury or death to personnel. • Escaping hydraulic fluid under pressure can penetrate the skin, causing serious injury to personnel. Relieve pressure before disconnecting hydraulic lines and fittings. Tighten all connections before applying pressure. Keep hands and body away from pinholes and nozzles that eject hydraulic fluid under high pressure. Use a piece of cardboard or paper to search for leaks. If any hydraulic fluid is injected into the skin, it MUST be surgically removed within a few hours by a doctor familiar with this type of injury or gangrene may result. NOTE • Procedures are the same for front and rear dollies. Rear dolly is illustrated. 1. Disconnect two hose assemblies (6) from straight connectors (5) at positioning cylinders (2) inside bottom beam (3). 2. Remove two straight connectors (5) and preformed packings (4) from positioning cylinders (2). Discard preformed packings. 3. Attach a suitable lifting device to top beam (1) and adjust so that weight of top beam is on the lifting device.