MWO-9-2330-390-35-1 HMMWV M1022A1 Dolly Set Positioning Tube Reinforcement Download
Page 11 of 48
MWO 9-2330-390-35-1 11 person reporting the MWO data, will acquire the remaining elements (3 & 5), and input all nine into MMIS. DATA Elements Input Data 1. Material Change Number (MCN) 2. MWO Number 3. Unit Identification Code (UIC) @ Battalion Level 4. NSN of End Item 5. Serial Number 6. USA Registration Number 7. Date of Application 8. Hours required for Application. 9. Software Version (3) For off- line reporting, the 3.5- inch disk shall be mailed to the following address: Commander TACOM-Warren ATTN: AMSTA-LC-CIPWM Warren, MI 48397-5000 b. Marking Equipment. (1) After the Positioning Tube Reinforcement Kit is installed, mark MWO under 9-2330-390-35-1 in the MWO Applied block and Date Applied in Date Block on MWO instruction plate P/N 10930014 (91). (2) To install the MWO instruction plate, locate and drill a 0.082-0.086 inch diameter hole on the front upper left (hydraulic valve side) vertical tube above the instruction plate (see figure 11). Use #4-3/16 drive screws to attach. 15. MATERIAL CHANGE (MC) NUMBER. a. The Material Change (MC) Number for this MWO is 1-02-08-0001 16. MODIFICATION IDENTIFI CATION. a. When installed correctly, the Positioning Tube Reinforcement Kit will appear as shown in figure 10. b. After the Positioning Tube Reinforcement Kit is installed, the positioning tube reinforcement should be inspected for secure mounting. Any faults detected, or discrepancies noted, will be corrected before the dolly is returned to normal service.