MWO-9-2330-390-35-1 HMMWV M1022A1 Dolly Set Positioning Tube Reinforcement Download
Page 10 of 48
MWO 9-2330-390-35-1 10 b. Installer Responsibilities. The installer is responsible for following instructions in MWO 9-2330-39-35-1, and TM 9-2330-390-14&P. The installer will report Positioning Tube Reinforcement Kits received that are damaged or missing component parts so the kit supplier can be properly notified. Any discrepancies noted will be corrected before the vehicle leaves the installer’s work area. Requirements contained in this MWO shall be included in the installer’s inspection plan or quality assurance program. As a minimum, a checklist will be maintained indicating all requirements have been satisfactorily accomplished for each kit. These requirements shall not be construed as eliminating the installer’s responsibility from complete compliance with provisions of the contract and submitting to the Government products that meet all requirements of the contract. c. Government Verification. All QA operations, installation changes, and inspections performed by the installer are subject to Government verification at unannounced and varying intervals. Verification will consist of observations and inspections to confirm that practices, methods, and procedures of the installer’s written inspection plan are being properly applied; and that Government product inspection to confirm the quality of product offered for Government acceptance does not deviate from prescribed acceptance standards specified in TM 9-2330- 390-14&P. Deviations will be brought to the attention of the installer for correction. d. In-process Inspection. During normal assembly operations, paragraph 10, Modification Procedure, will be used to check the installer’s work. After installation is complete, the installer will correct any defects noted before the Dolly is placed in service. All Dollies modified during a production shift will be checked to ensure product quality. 14. RECORDING AND REPORTING OF THE MODIFICATION. a. Records and Reports. The organization responsible for MWO application will report application information as follows: (1) Reporting will be accomplished by electronic means. MWO application information can be input directly into the Modification Management Information System (MMIS) over the Internet. If Internet is not available, recording will be on a 3.5-inch disk, which will be mailed to the MMIS administrator. Entry into the MMIS system is password protected. New users can register on-line at http://208.242.67.250/mwo . Passwords are normally approved and issued within 48 hours. (2) Submission will be comprised of nine (9) data elements listed in the table below. Elements 1,2,4,6,7,8 & 9 are given for this MWO (as shown). The