MWO-9-2330-390-25-1 HMMWV M1022A1 Dolly Set Positioning Tube Reinforcement Download
Page 11 of 54
MWO 9-2330-390-25-1 9 (3) For off-line reporting, the 3.5-inch disk shall be mailed to the following address: Commander TACOM-Warren ATTN: AMSTA-LC-CIPWM Warren, MI 48397-5000 b. Marking Equipment. (1) After the Positioning Tube Reinforcement Kit is installed, mark MWO under 9-2330-390-25-1 in the MWO Applied block and Date Applied in Date Block on MWO instruction plate P/N 10930014 (91). (2) To install the MWO instruction plate, locate a single 0.107 inch diameter hole (#37 - drill size) on the front upper left (hydraulic valve side) vertical tube above the instruction plate (see figure 9). Use #4-3/16 drive screws (32) to attach. 15. MATERIAL CHANGE (MC) NUMBER. a. The Material Change (MC) Number for this MWO is 1-05-08-0001 16. MODIFICATION IDENTIFICATION. a. When installed correctly, the Positioning Tube Reinforcement Kit will appear as shown in figure 7. b. After the Positioning Tube Reinforcement Kit is installed, the positioning tube reinforcement should be inspected for secure mounting. Any faults detected, or discrepancies noted, will be corrected before the dolly is returned to normal service.