MWO-9-2320-280-35-2 HMMWV 3-Point Seatbelt Restraint System Download
Page 14 of 116
MWO 9-2320-280-35-2 9 NSN NOMENCLATURE CAGEC PART NO. QTY. Template 19207 12342729 1 Template 19207 12342730 1 Template 19207 12342732 1 Template 19207 12342733 1 Template 19207 12342737 1 Template 19207 12342738 1 Template 19207 12342739 1 Template 19207 12342740 1 10. MODIFICATION PROCEDURES. 10.1. FRONT SEAT, NON-ARMORED VEHICLE. WARNING All seatbelt anchor point hardware must be replaced with the new hardware provided in the kit to ensure adequate strength. Failure to do this may result in injury to personnel. NOTE Body side panels beneath the "B" pillar must be free of dents and/or body filler material to ensure structural rigidity when reinforcements are installed. Body side panels damaged or previously repaired must be replaced prior to installation of this kit. a. VEHICLE PREPARATION. (1) Disconnect battery ground cable. (Refer to TM 9-2320-280-20.) (2) Remove fixed doors, if installed. (Refer to TM 9-2320-280-20.) (3) Remove cargo barrier, if installed. (Refer to TM 9-2320-280-20.) (4) Remove rear curtain, if installed. (Refer to TM 9-2320-280-20.) (5) Remove rear seat backs, if installed in stowed position. (Refer to TM 9-2320-280-20.) (6) Remove enclosure panels. (Refer to TM 9-2320-280-20.) (7) Remove driver's seat and seat back cushions. (Refer to TM 9-2320-280-20.) (8) Remove driver's seat frame. (Refer to TM 9-2320-280-20.) (9) Remove shelter, if installed. (Refer to TM 9-2320-280-20.) (10) Remove troop seats, if installed. (Refer to TM 9-2320-280-20.) (11) Remove companion seat back. (Refer to TM 9-2320-280-20.) (12) Remove front seatbelt assemblies. (Refer to TM 9-2320-280-20.) b. LEFT RABBET REINFORCEMENT INSTALLATION. NOTE It may be necessary to replace identification data plate if damaged during removal. (1) Mark an outline around identification data plate and driver's seat adjustment decal on left rabbet assembly as shown in figure 1.