MWO-9-2320-280-35-2 HMMWV 3-Point Seatbelt Restraint System Download
Page 36 of 116
MWO 9-2320-280-35-2 31 c. Government Verification. All QA operations and installation checks and inspections performed by the installer are subject to Government verification at unannounced and varying intervals. Verification will consist of observations and inspections to confirm that practices, methods, and procedures of the installer's written inspection plan are being properly applied; and that Government product inspection to confirm the quality of product offered for Government acceptance does not deviate from prescribed acceptance standards specified to in TM 9-2320-280-10, TM 9-2320-280-20, and TM 750-245-4. Any deviations will be brought to the attention of the installer for correction. d. In-Process Inspection. During normal assembly operations, applicable modification paragraphs will be used to check the installer's work. After installation is complete, the vehicle will be checked IAW the PMCS check list for correct functioning of the 3-Point Seatbelt Retrofit Kit components and to ensure there are no defective seatbelts. Any defects noted will be corrected by the installer before the vehicle is placed in service. All vehicles modified during a production shift will be checked to ensure product quality. e. Workmanship Inspection. Inspect all components installed or replaced during the installation of the MWO for smoothness of operation and security of mounting. Correct any faults found. 14. RECORDING AND REPORTING OF THE MODIFICATION. a. Records and reports. (Refer to DA PAM 738-750.) b. Marking Equipment. (1) After 3-Point Seatbelt Retrofit Kit Modification is installed, mark MWO number "9-2320-280-35-2" in the MWO Applied Block and date applied in Date Block on MWO Instruction Plate 10930014. NOTE Do not remove previously installed MWO instruction plate(s) that are permanently affixed to reinforcement panel prior to this MWO installation. (2) Install 10930014 MWO instruction plate by drilling a 0.104-inch diameter hole within designated area on side body reinforcement panel and secure with MS21318-20 drive screw as shown in figure 67. (3) After drive screw is installed, flatten or remove protruding excess drive screw material from inside of side body reinforcement panel. c. Identification Data. Not applicable. 15. MATERIAL CHANGE (MC) NUMBER. This MWO is authorized by MC number 1-92-06-4401. 16. MODIFICATION IDENTIFICATION. a. When installed correctly, the 3-Point Seatbelt Retrofit Kit Modification will appear as shown in figures 68, 69, 70, and 71 (Front Seat, Non-Armor), figure 72 (Rear Seat, Non-Armor), and figures 73, 74, 75, and 76 (Front and Rear Seats, Basic Armor). a. After the 3-Point Seatbelt Retrofit Kit Modification is completed, the High-Mobility Multipurpose Wheeled Vehicle should be checked for secure mounting and smooth operation. Any faults detected or discrepancies noted will be corrected before the vehicle is returned to normal service.