MWO-9-2320-280-35-2 HMMWV 3-Point Seatbelt Restraint System Download
Page 21 of 116
MWO 9-2320-280-35-2 16 Change 2 NOTE Ensure seatbelt strap is positioned over "B" pillar padding assembly during installation. (9) Loosen two screws and plate on 12342954 "B" pillar padding assembly. Position "B" pillar padding assembly to bracket assembly (12342683) on right "B" pillar as shown in figure 32. (10) Install 12341856 washer and "D" ring (part of seatbelt assembly 12480530) to "B" pillar padding assembly (12342954) and bracket assembly (12342683) on right "B" pillar and secure with 12340259-7 bolt as shown in figure 32. Tighten bolt to 35-40 lb-ft (48-54 N • m). (11) Using slots in "B" pillar padding assembly (12342954), slide two screws and plate upward until plate makes contact with bottom of bracket assembly (12342683) as shown in figure 32A. (12) Secure plate to bottom of bracket assembly (12342683) with two screws as shown in figure 32A. Tighten screws to 30 lb-in. (3 N • m). NOTE Perform steps (13), (14), and (15) only if two-man soft-top assembly is installed. (13) Install 12342959 extension assembly to left side of top assembly as shown in figure 33A. (14) Install 12342959 extension assembly to right side of top assembly as shown in figure 33A. (15) Secure top assembly and rear curtain of two-man soft-top assembly to turnbuttons on left and right side of "B" pillar as shown in figure 33. m. FINAL PREPARATION. NOTE Steps (1) and (2) below do not apply to vehicles equipped with high back seat. (1) Install existing two rods, bushings, and MS16562-20 pins to 12338503-1 seat assembly as shown in figure 34. (2) Install existing seat back and cushion to seat assembly. (Refer to TM 9-2320-280-20.) (3) Install driver's seat assembly. (Refer to TM 9-2320-280-20.) (4) Install companion seat back. (Refer to TM 9-2320-280-20.) (5) Install enclosure panels, if removed. (Refer to TM 9-2320-280-20.) (6) Install cargo barrier, if removed. (Refer to TM 9-2320-280-20.) (7) Install fixed doors, if removed. (Refer to TM 9-2320-280-20.) (8) Install rear seat backs, if removed. (Refer to TM 9-2320-280-20.) (9) Install rear curtain, if removed. (Refer to TM 9-2320-280-20.) (10) Install shelter, if removed. (Refer to TM 9-2320-280-20.) (11) Install troop seats, if removed. (Refer to TM 9-2320-280-20.) (12) Connect battery ground cable. (Refer to TM 9-2320-280-20.) (13) Spot paint as necessary. (Refer to TM 43-0139.)