MWO-9-2320-280-35-1 HMMWV Dual Service Parking Brake Download
Page 6 of 20
MWO 9-2320-280-35-1 c. INSTALLATION, RIGHT PARKING BRAKE CABLE. (1) Secure brake cable bracket to support bracket with two 456644 screws as shown in figure 4. Tighten 6 lb-ft (8 N·m). (2) Install MS21333-105 clamp on 12341898-1 cable assembly and secure clamp to brake cable bracket with MS35338-44 washer and MS90728-5 screw as shown in figure 4. (3) Route cable assembly over fuel tank and insert brake cable sleeve of cable assembly through C-beam and secure with MS16633-1050 ring clip as shown in figure 4. (4) Install two MS21333-104 clamps to cable assembly and secure clamps to cargo floor support with two 9431948 screws as shown in figure 5. d. INSTALLATION, LEFT PARKING BRAKE CABLE/MOUNTING BRACKET. (1) Secure brake cable bracket to support bracket with two 456644 screws as shown in figure 4. Tighten 6 lb-ft (8 N·m). (2) Install MS21333-105 clamp on 12341898-3 cable assembly and secure clamp to brake cable bracket with MS35338-44 washer and MS90728-5 screw as shown in figure 4. (3) Route cable assembly over frame rail and insert brake cable sleeve of cable assembly through C-beam and secure with MS16633-105O ring clip as shown in figure 4. (4) Install 12341906 parking brake cable mounting bracket and tailpipe hanger to rear body mount and secure with two existing screws, four existing washers and two 9422297 nuts as shown in figure 6. (5) Install MS21333-104 clamp to cable assembly and secure to parking brake cable mounting bracket with MS90725-6 screw, MS27183-10 washer, and 271172 nut as shown in figure 6. e. INSTALLATION, PARKING BRAKE ROD. (1) Position 12341902 equalizer bar on parking brake cable ends as shown in figure 7. (2) Remove clevis, spring, nut, two washers, screw, and spacer from existing parking brake rod as shown in figure 8. (3) Install spring and spacer to body support and secure with two washers, screw, and MS51943-33 nut as shown in figure 7. (4) Install MS51968-6 nut and clevis on 12341895 brake rod as shown in figure 7. (5) Slide brake rod rearward through spring as shown in figure 8. (6) Connect brake rod to equalizer bar and secure with 12341897 conical washer and MS51943-34 nut as shown in figure 7. Install nut exposing 3-5 threads on end of brake rod. (7) Spread boot and install clevis to bellcrank and secure with 138084 clevis pin, 2436163 washer, and 121222 cotter pin as shown in figure 7. (8) Insert brake cable sleeves through slot of calipers and secure with two MS16633-1050 ring clips as shown in figure 4. (9) Install clevis to rear caliper levers and secure with two clevis pins, washers, and two 121222 cotter pins as shown in figure 3. (10) Install muffler. (Refer to TM 9-2320-280-20.) 6