MWO-9-2320-280-20-6 HMMWV Airlift Bumper Reinforcement M1097 M1097A1 M1025A2 M1097A2 M1113 M1114 Download
Page 6 of 18
6. USA Registration Number 7. Date of Application 8. Hours required for Application. 9. Software Version (3) For off-line reporting, the 3.5-inch disk shall be mailed to the following address: Commander TACOM-Warren ATTN: AMSTA-LC-CIPWM Warren, MI 48397-5000 b. Marking Equipment. (1) After Airlift Bumper Reinforcement Modification Kit is installed, mark MWO under “9-2320-280- 20-6” in the MWO Applied block and date applied in Date block on 10930014 MWO instruction plate. NOTE NOTE • Do not remove any existing MWO instruction plates affixed to the reinforcement panel. • Perform steps 2 and 3 for M1097, M1097A1, M1025A2, M1097A2, M1113, and step 4 for M1114. (2) Install MWO instruction plate 10930014 by drilling a 0.104-inch diameter hole (#37 drill bit) within designated area on left side body reinforcement panel and secure with MS21318-20 drive screw as shown in figure 7. (3) After drive screw is installed, flatten or remove protruding excess drive screw material from inside of side body reinforcement panel. (4) Apply versilok adhesive 204 on back of MWO instruction plate 10930014 and install on left side body armor panel as shown in figure 8. 15. MATERIAL CHANGE (MC) NUMBER. This MWO is authorized by (MC) number 1-00-06-0009. 16. MODIFICATION IDENTIFICATION. a. When installed correctly, the Airlift Bumper Reinforcement Modification Kit will appear as shown in figure 9. b. After the Airlift Bumper Reinforcement Modification Kit is installed, the airlift bumper reinforcement should be inspected for secure mounting. Any faults detected, or discrepancies noted, will be corrected before the vehicle is returned to normal service. c. After the vehicle is modified it will be “AUTHORIZED TO TOW TRAILERS WITH MAX GROSS WEIGHT OF 4,200 LB (1,907 KG)”. MWO 9-2320-280-20-6 6