TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 99 of 796
TM 9-2320-366-34-4 NOTE • Use bolts P/N 12414307-142 and self-locking nuts P/N 12414308-025 on step (53). • Support will be installed with fitting facing down. (53) Position support (12) on pintle hook extension (57) with four bolts (11) and self-locking nuts (10). (54) Position pintle hook extension (57) in vise. (55) Tighten four self-locking nuts (10) to 196-240 lb-ft (265- 325 N·m). (56) Position pintle hook (8) in pintle hook extension (57) with washer (7) and nut (6). CAUTION Clearance between washer and support must be 0.003-0.017 in. (0.076-0.432 mm). Failure to comply may result in damage to equipment. (57) Adjust nut (6) until clearance is 0.003-0.017 in. (0.076- 0.432 mm) with alignment holes lined up between nut (6) and pintle hook (8). (58) Install cotter pin (5) in nut (6). Change 1 18-45