TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 65 of 796
TM 9-2320-366-34-4 NOTE • Use bolts P/N 12414307-142 on step (47). • Support will be installed with grease fitting facing down. (47) Position support (19) on pintle hook extension (80) with four bolts (18) and self-locking nuts (17). (48) Position pintle hook extension (80) in vise. (49) Tighten four self-locking nuts (17) to 196-240 lb-ft (265- 325 N·m). (50) Position pintle hook (15) in pintle hook extension (80) with washer (14) and nut (13). CAUTION Clearance between washer and support must be 0.003-0.017 in. (0.076-0.432 mm). Failure to comply may result in damage to equipment. (51) Adjust nut (13) until clearance is 0.003-0.017 in. (0.076- 0.432 mm) with alignment holes lined up between nut (13) and pintle hook (15). (52) Install cotter pin (12) in nut (13). Change 1 18-11