TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 518 of 796
TM 9-2320-366-34-4 Section II. MAINTENANCE PROCEDURES 27-2. M1090/M1094 DUMP BODY LIFT CYLINDER REPAIR This task covers: a. Disassembly b. Cleaning/Inspection c. Assembly INITIAL SETUP Tools and Special Tools Tool Kit, Genl Mech (Item 78, Appendix B) Wrench, Torque 0-600 lb-ft (Item 97, Appendix B) Wrench Set, Spanner (TM 9-2320-366-20) Multiplier, Torque Wrench (Item 42, Appendix B) Goggles, Industrial (Item 28, Appendix B) Wrench Set, Socket (Item 84, Appendix B) Pan, Drain (Item 43, Appendix B) Gloves, Rubber (Item 26, Appendix B) Materials/Parts Kit, Seal (Item 117, Appendix F) Tape, Antiseizing (Item 85, Appendix C) Packing, Preformed (Item 288, Appendix F) Materials/Parts (Cont) Packing, Preformed (Item 287, Appendix F) Nut, Self-Locking (Item 196, Appendix F) Washer, Wave (Item 439, Appendix F) Spacer, Nylon (Item 421, Appendix F) Sealing Compound (Item 69, Appendix C) Solvent, Dry Cleaning (Item 83, Appendix C) Rag, Wiping (Item 60, Appendix C) Lubricating Oil, Engine (Item 46, Appendix C) Personnel Required (2) a. Disassembly. WARNING Dump body lift cylinder weighs approximately 200 lbs (91 kg). Attach a suitable lifting device prior to lifting. Failure to comply may result in injury to personnel or damage to equipment. (1) Place drain pan under lift cylinder barrel (1). (2) Extend cylinder rod (2) approximately 12 inches (31 cm). (3) Loosen screw (3) on collar (4). (4) Remove collar (4) from lift cylinder barrel (1). (5) Remove lubrication fitting (5) from lift cylinder barrel (1). 27-2