TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 451 of 796
TM 9-2320-366-34-4 (5) Position motor housing (2) in vise with output shaft (1) up. WARNING Adhesive Sealant MIL-S-46163 can damage your eyes. Wear safety goggles when using; avoid contact with eyes. If sealant contacts eyes, flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (6) Apply sealing compound to four screws (10). (7) Position motor housing flange (8) on output shaft (1) with four screws (10). CAUTION Tighten screws in a crisscross pattern to properly seat mounting flange. Failure to comply may result in damage to equipment. (8) Tighten screws (10) to 21 lb-ft (28 N·m). (9) Reposition motor housing (2) in vise with output shaft (1) down. CAUTION Mark bolt hole on motor housing that aligns with timing mark on output shaft. Failure to comply may result in damage to equipment. (10) Align timing mark on output shaft (1) with any bolt hole in motor housing (2). (11) Install preformed packing (11) on motor housing (2). (12) Install spur gear shaft (12) in output shaft (1). (13) Fill motor housing (2) with lubricating oil. (14) Install spacer plate (13) on motor housing (2). 26-17