TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 429 of 796
TM 9-2320-366-34-4 b. Cleaning/Inspection. WARNING Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in serious injury or death to personnel. (1) Clean all metal parts thoroughly with dry cleaning solvent. NOTE Replace any part that fails visual inspection. (2) Inspect all metal parts for uneven wear, pitting, or nicks. c. Assembly. NOTE Apply lubricating oil to parts during assembly. (1) Install nylon plug (1) in cylinder rod retainer (2). (2) Trim nylon plug (1) even with threads of cylinder rod retainer (2). (3) Install dust seal (3) in cylinder rod retainer (2). 25-31