TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 398 of 796
TM 9-2320-366-34-4 24-3. REAR AXLE DIFFERENTIAL CARRIER REPAIR (CONT) NOTE Perform step (5) if backlash reading is less than 0.008 in. (0.020 cm). (5) Loosen adjusting ring (3) on back side of hub body (4) and tighten adjusting ring (5) facing the ring gear (2) to increase backlash. NOTE Perform step (6) if backlash reading is greater than 0.018 in. (0.045 cm). (6) Tighten adjusting ring (3) on back side of hub body (4) and loosen adjusting ring (5) facing the ring gear (2) to decrease backlash. (7) Repeat steps (2) through (6) until backlash is between 0.008-0.018 in. (0.020-0.045 cm). (8) Tighten four screws (6) to 132-169 lb-ft (179-229 N·m). (9) Install two cotter pins (7) in bearing caps (8). WARNING Rear differential carrier weighs approximately 350 lbs (159 kgs). Attach a suitable lifting device prior to moving. Failure to comply may result in injury to personnel or damage to equipment. NOTE Step (10) requires the aid of an assistant. (10) Remove differential carrier (9) from differential carrier repair stand. End of Task. 24-40 Change 1