TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 395 of 796
TM 9-2320-366-34-4 NOTE • Perform steps (38) and (39) only if a new pinion drive and drive gear set were installed. If old pinion drive and ring gear set is installed, go to step (40). • The pinion cone variation number can be either 0.001 in. or 0.001 cm. For example, PC +4 equals +0.004 in., PC -.005 cm equals -0.005 cm. (38) If pinion cone variation number recorded in step (15) of disassembly is negative, subtract it from the thickness of the shims. If number is positive, add it to the thickness of the shims. Refer to Table 24-3 Pinion Cone Variation Chart. NOTE The value obtained from step (38) is the thickness of the new shims to be installed. Use as many shims as required to equal the value obtained from step (38). (39) If pinion cone variation number recorded in step (19) of assembly is negative, subtract it from value the thickness of the shims. If number is positive, add it to the thickness of the shims. Refer to Table 24-3 Pinion Cone Variation Chart. Table 24-3. Pinion Cone Variation Chart PINION CONE VARIATION NUMBER EQUIVALENT MEASUREMENT PC +1 through PC +9 +0.001 in. through +0.009 in. +1 through +9 PC -1 through PC -9 -0.001 in. through -0.009 in. -1 through -9 PC +.001 cm through +.009 cm +0.001 cm through +0.009 cm +.001 cm through +.009 cm PC -.001 cm through PC -.009 cm -0.001 cm through -0.009 cm -.001 cm through -.009 cm 24-37