TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 388 of 796
TM 9-2320-366-34-4 24-3. REAR AXLE DIFFERENTIAL CARRIER REPAIR (CONT) CAUTION Pinion drive and ring gear are machined in matched sets and must be replaced at the same time. Failure to comply may result in damage to equipment. (18) Inspect pinion drive (15) for visible cracks, wear, or damage. (19) Inspect ring gear (16) for visible cracks, wear, or damage. (20) Inspect differential case (17) for visible cracks, wear, or damage. (21) Inspect hub body (18) for visible cracks, wear, or damage. c. Assembly. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (1) Apply four or five drops of adhesive sealant in 16 threaded holes on hub body (1). (2) Apply sealing compound to mounting surface of hub body (1). (3) Position ring gear (2) on hub body (1) with 16 washers (3) and screws (4). (4) Tighten 16 screws (4) to 85-115 lb-ft (115-156 N·m). (5) Install bearing cone (5) on hub body (1). 24-30