TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 377 of 796
TM 9-2320-366-34-4 (60) Install preformed packing (60) on bearing cage (2). (61) Apply gear oil to preformed packing (60). NOTE End play of the input shaft assembly is adjusted by thickness of shim pack. Measure the gap between the input bearing cage and differential carrier at four equally spaced points. Add all four measurements together and divide by four to determine the average gap. Add 0.005 in. (0.012 cm) to the average gap value. (62) Position bearing cage (2) on differential carrier (14) with eight screws (61). (63) Measure gap between bearing cage (2) and differential carrier (14). Record measurement. (64) Remove eight screws (61) and bearing cage (2) from differential carrier (14). WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well- ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (65) Apply adhesive sealant to shim pack (62) and mounting flange of differential carrier (14). (66) Position shim pack (62) and bearing cage (2) on differential carrier (14) with eight washers (63) and screws (61). (67) Tighten screws (61) to 74-96 lb-ft (100-130 N·m). (68) Tighten self-locking nut (8) to 450-601 lb-ft (610-815 N•m). (69) Tighten self-locking nut (55) to 450-601 lb-ft (610-815 N·m). (70) Install oil pump (64) on pinion drive shaft (9) Change 1 24-19