TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 372 of 796
TM 9-2320-366-34-4 24-2. INTERMEDIATE DIFFERENTIAL REPAIR (CONT) (18) Remove bearing cone (17) from pinion drive shaft (9). (19) Remove pinion drive shaft (9) from differential carrier (14). (20) Remove helical driven gear (15) and spacer (16) from differential carrier (14). NOTE Install thinner spacers to increase preload and thicker spacers to decrease the preload. (21) Repeat steps (9) through (15) to determine if preload on bearing cones is within specifications. WARNING Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well- ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. (22) Apply four or five drops of adhesive sealant in 16 threaded holes on hub body (19). (23) Apply sealing compound to mounting surface of hub body (19). (24) Position ring gear (20) on hub body (19) with 16 washers (21) and screws (22). (25) Tighten screws (22) to 85-115 lb-ft (115-156 N·m). (26) Install bearing cone (23) in hub body (19). (27) Install thrust washer (24) and slide gear (25) in ring gear (20). 24-14