TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 370 of 796
TM 9-2320-366-34-4 24-2. INTERMEDIATE DIFFERENTIAL REPAIR (CONT) NOTE Perform steps (6) through (8) if pinion drive and drive gear set were replaced. If old pinion drive and drive gear is installed, go to step (9). (6) Record pinion cone variation number at gear end of pinion drive shaft (9). (7) Record thickness of shim pack (10) that was removed from pinion drive shaft (9). NOTE The pinion cone variation number can be either 1000th of an in. or 1000th of a cm. For example, PC +4 equals +0.004 in., PC-0.005 cm equals -0.005 cm. Table 24-1. Pinion Cone Variation Chart PINION CONE VARIATION NUMBER EQUIVALENT MEASUREMENT PC +1 through PC +9 +0.001 in. through +0.009 in. +1 through +9 PC -1 through PC -9 -0.001 in. through -0.009 in. -1 through -9 PC +0.001 cm through PC +0.009 cm +0.001 cm through +0.009 cm +0.001 cm through +0.009 cm PC -0.001 cm through PC -0.009 cm -0.001 cm through -0.009 cm -0.001 cm through -0.009 cm (8) If pinion cone variation number recorded in step (42) of disassembly is negative, subtract it from the thickness of the shim pack. If number is positive, add it to the thickness of the shim pack. 24-12