TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download
Page 366 of 796
TM 9-2320-366-34-4 24-2. INTERMEDIATE DIFFERENTIAL REPAIR (CONT) b. Cleaning/Inspection. WARNING Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result in serious injury or death to personnel. If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help. If dry cleaning solvent contacts skin or clothes, flush with cold water. If dry cleaning solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. Failure to comply may result in injury to personnel. (1) Clean sealant residue from threaded holes with dry cleaning solvent. CAUTION Wash machined parts separately to avoid damage from parts bumping together. Failure to comply may result in damage to equipment. (2) Clean all metal parts with dry cleaning solvent. WARNING Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.). Failure to comply may result in injury to personnel. (3) Dry all metal parts, except bearing cones with compressed air. Allow bearing cones to air dry. NOTE Replace any part that fails visual inspection. (4) Inspect oil filter screen (1) for visible cracks, tears or damage. (5) Inspect oil pump cover (2) for visible cracks or damage. 24-8