TM-9-2320-366-34-4 MTV Direct Maintenance Manual M1083 Series - Volume 4 Download

Page 355 of 796

TM 9-2320-366-34-4 Change 2 23-17 (40) Apply adhesive sealant to shims (36) and mounting flange of differential carrier housing (17). (41) Position shims (36), bearing cage (29), and pinion drive (25) on differential carrier housing (17) with eight washers (37) and screws (32). (42) Tighten eight screws (32) to 44-55 lb-ft (60-75 N•m). (43) Apply a small amount of sealing compound to outside edge of yoke seal (38). (44) Install yoke seal (38) on input yoke (33). (45) Apply adhesive sealant to threads of self-locking nut (34). (46) Install input yoke (33) on pinion drive (25) with self- locking nut (34). (47) Tighten self-locking nut (34) to 920-1130 lb-ft (1248- 1532 N•m). WARNING Adhesives, solvents, and sealing com- pounds can burn easily, can give off harmful vapors, and are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap and water. Failure to comply may result in injury to personnel. NOTE A minimum of three shims must be installed.